In a message dated 4/21/01 6:37:36 AM Pacific Daylight Time,
tomntam@earthlink.net writes:
<<
This may have been asked but I didn't make note of it so I am asking again.
I have a rebuilt TH350 and new torque converter. Is there a method to
adding trans fluid to the transmission and converter?
thanks tom
>>
Hey Tom,
I believe if the TH350 and converter are dry, it will take about 10.5
quarts, but call around to verify.
You'll want to fill it through the dipstick tube.
Get the tranny to operating temp, then place the selector in drive to
reverse a few times, then back into park (with the motor running) and check
the fluid again.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|