I had a chock cable that worked and needed to add a repro throttle cable. I
have completed this - what fun it is under the dash. I have it hooked up
just like the old frozen one was. I can work the throttle from the button.
However it is not working in the same way as the chock. The chock will stay
out to exactly where I place it. The throttle will slide back in and only
let me keep the motor throttled up a little. Also I would like to make it
so that the T is upright. I can get it to spin about 30 degrees off on
either side of up but I can not get it to stay upright. I have attempted to
re-connect the cable end to move the T with no change. Any ideas on what
needs to be done to tweak this?
Thanks,
Jim House
46 Chevy 3104
Hollis, NH
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|