It might be for a 216 and not a 235 which might be the motor you have.
Sincerely,
Dave Shier
www.mtntown.com
Michael Mendonca wrote:
> I just acquired an Edmund's Dual intake manifold and noticed that while it
>lines up perfectly with the intake ports, the insert rings don't quite fit
>into the manifold..the recessed portion of the manifold is about 1/8 inch too
>small. Is this to be expected? Is it the wrong manifold? Can I grind the
>manifold to fit the rings or can I get different rings?
>
> Any thoughts out there?
>
> Thanks for your help.
>
> Michael
> '54 Chevy 3100
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|