Mercedes come standard with claw holes
in the seats. Maybe the cat was just
trying to improve the Sportster.
-----Original Message-----
From: bob_keeland@usgs.gov [mailto:bob_keeland@usgs.gov]
Sent: Wednesday, January 10, 2001 8:02 AM
To: oletrucks@autox.team.net
Subject: Re: [oletrucks] side boards
Of course another way to incorporate stops would be to either make the
vertical posts a bit too wide for the holes and then trim them down for the
length that will go into the pocket holes, or you could attach stops on
the side of the vertical posts so that the posts can only go into the hole
as far as you want. If you add some type of rubber or such on the bottom
of the stops they should not damage the paint too much. Always more than
one way to skin a cat (especially after they claw holes in the seat of your
sportster . . .).
BobK
51 3600 5-window (project)
98 RAM (hers)
99 Sportster (with holes in the seat)
Arnaudville, LA
MKlepp4335@cs.com
Sent by: To: tcape@weblnk.net,
jhouse@ccsolution.com,
owner-oletrucks@auto oletrucks@autox.team.net
x.team.net cc:
Subject: Re: [oletrucks]
side boards
01/09/01 08:13 PM
Please respond to
MKlepp4335
In a message dated 1/9/01 7:54:05 PM Central Standard Time,
tcape@weblnk.net
writes:
<< Each pocket hole is supposed to have a "stop" about 4-5 inches down in
the
hole. Looks like someone has removed these on your truck. >>
The repo bed sides I am now finishing with new bed wood have no stops in
them
either. I suppose an alternative would be to drill a small hole through
the
bed from the inside and use a single wood screw into the upright pieces. I
don't think I can drill a hole in that newly painted virgin metal. I guess
I'll wait a few years.
Mike Klepp
'48 3100
Wichita Falls, TX
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|