The chain will be a whole lot easier to remove when done, than the pebbles
will.
Regards,
Doug Pewterbaugh
dpewter@msn.com
Denton, TX
49 3104 216 5-window
----- Original Message -----
From: Jon Kunkel <jonkunkel@home.com>
To: <Mikerross@aol.com>
Cc: <oletrucks@autox.team.net>
Sent: Sunday, July 16, 2000 9:26 AM
Subject: Re: [oletrucks] Gas Tank Coating
> Mike,
> I used the kit from Eastwood Co. They supply a chain which is what I used
> to loosen all the remaining rust and debris. It did an excellent job. I
> don't see a problem with the smooth pebbles except if they break up.
> Jon 50 3100
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> ----- Original Message -----
> From: <Mikerross@aol.com>
> To: <ADvent@thuntek.net>
> Cc: <oletrucks@autox.team.net>
> Sent: Sunday, July 16, 2000 8:13 AM
> Subject: [oletrucks] Gas Tank Coating
>
>
> > Guys I am in the process of coating the inside of my trucks gas tank. I
> was
> > amazed at all the rust and junk that came out of the tank. Has anyone
> used a
> > gas tank coating? I ordered mine from Chevy Duty. Any "lessons
learned"?
> >
> > It seems like I need to loosen the remaining rust and stuff in the tank
> > before coating. I though about dropping a few handfuls of clean pebbles
> into
> > the tank and gently roll them back and forth hopefully loosening up the
> rust
> > and stuff.
> >
> > Any experiences you've had would be much appreciated.
> >
> > Thx.
> >
> > Mike
> > '56 Chevy Truck
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|