Re: [oletrucks] Clutch Head tools and Steering columns and seats andpwr

[ADvent@thuntek.net]

where did you buy them? i bought them from snap on. your measurements sound
right, there are only 4 that you need.
new mexico jim
51 two ton dump
50 ½ ton

Pastorjon994@cs.com wrote:

> Hey Jim & friends,
>     What are the clutch head sizes most needed for work on our trucks?  I
> bought a few bits for my drill today, 1/8,3/16 & 5/32.  I would like to get
> sockets for the most common sizes used on my truck.

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959