I have a set of rims from a 89 S10 blazer, they also have all most no backset.
They
move the wheels in about 2 1/2 inchs, from a "standard" rim. I have been trying
to
figure a way to get the rear end from a '74 1/2 chevy pickup under a '50 3600
and so
far this seems to be the answer.
ADvent@thuntek.net wrote:
> This is just an idea, but if you go to 5 bolt hubs, you might be able to use
> Eldorado wheels to move them in a bit. The bolting flange on those wheels
>will set
> the wheels in about 3 inches.
> new mexico jim
> 51 two ton dump
> 50 ½ ton
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|