I used the tube type from Chevy Duty and it is working fine. It fit fine, I
bolted mine in place although drilling the holes was a bit of a job.
Andy 56-3200
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of J & M Street
Sent: Wednesday, December 01, 1999 12:09 AM
To: oletrucks@autox.team.net
Subject: [oletrucks] Which motor mounts to use in TF
Hi folks, I'm installing a small block 350 engine in my '55-2 which has
a must. II front end installed and the frame has been boxed. I'm
wondering which motor mounts to use. It has been suggested that I use
the weld in tube cross member type but I'm not sure if it would fit. Any
suggestions? Thanks. Jeff
Jeff Street- Seattle WA. (what's left of it)
'55-2 short/step "Street's rod project"
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|