In redoing my GMC 55-2, I acquired a 67 Mustang rear end with 3.70 gears. I
found that the pumpkin is offset approx. 3 to 4 inches to the right side.
Can this still be placed into the frame with this much side offset or will I
have to center the pumpkin in the frame by having the axle tubes extended on
one side along with the axles?
I'm hoping the angle won't be a problem. If someone out there can give me
some advise, I would certainly appreciate it. TIA.
Steve B
GMC 55-2
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|