Hello all!!!
Im a 41 year from Calgary Alberta.
I have a project thats been in storage for quite some time.
I just started working on the running gear. Since the old running gear
was long past restoring . Ive decided to up grade the suspension and the
rear end and they drive line ( 350 ci and 400 turbo glide). Other than
that i hope to keep it looking fairly stock. So far I've replaced the
front end with a camaro clip and the rear end is out of the same
camero. What I've run into is what to do about the master cylinder. I
don't think the original one will be able to handle the disc brakes on
it. Any suggestions??? Is there kits out there to utilize my old
master cylinder or should i use a current one off of the same camero
type car. Might seem pretty simple to yous out there but i need some
input. Awaiting your out standing knowledge ... and thank you in
advance
Bruce
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|