I am trying to remove the brake master cyclinder on my 1957 3600. I removed
the bolts and brake lines but I have been unable to get the curved brake
pedal arm coming through the floorboards to separate from the pivot arm that
actuates the master cylinder. It is almost impossible to get an angle where a
5 lb hammer can be much help. Anyone else know of a way to get this to let
go? I am almost at the point of sawing the brake pedal off of the arm and
trying to reatttach it later. Help!
Rick in Iowa
57 3600 (took 3 trips to get it all home)
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|