In a message dated 5/12/99 1:14:22 PM Pacific Daylight Time,
pfoxtrot@gate.net writes:
<< One thing I did notice however was the gas gauge going nuts. When I
turned the ignition on the needle immediately jumped to near half tank
reading. Withiin a few seconds it started jumping to full scale then
falling back to the initial reading with a cycle period of a bit over a
second. >>
Paul,
The easiest thing to check is your power and ground. Could be a bunch of
other things - sending unit, or gauge itself, but start with your ground...
Good luck,
Tom
'49 3100
|