Craig,
I have used JNW engine on Piner with good success for Lotus projects. I also
held a tech session at Jerry's shop for club members, who got a good
introduction to his work and capabilities. I know of two other members who have
used his services since the tech session.
All of your needs are well within his abilities. Cost is reasonable but not
cut-rate. Tell him Greg Tatarian with the Lotus twincams, and from the NOBBC,
sent you.
Greg
------Original Message------
From: craig murphy
Sender: nobbc-bounces@autox.team.net
To: North Bay British Car Club
ReplyTo: North Bay British Car Club
Subject: [Nobbc] Machine shop
Sent: Feb 16, 2011 8:02 PM
Hello,
I'm looking for a recommendation of a good, reasonably priced machine shop or
retired machinist working out of his garage for some engine work for my '65
Mini Cooper S. I need to have the main journals line-honed as well as the rod
journals honed, new cam shaft bearings pressed in and possibly a light
resurfacing of the block.
Thanks in advance!
Craig Murphy1965 Morris Cooper S
_______________________________________________
Nobbc@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/nobbc/gtwincams@gmail.com
Sent via BlackBerry by AT&T
_______________________________________________
Nobbc@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|