Yes indeed, I did mean 2 11/16". I just measured it, but
lost track of the measurement as I was returning to my computer.
Sorry.
Dave K
---------------------------------------------------------------
>----- Original Message ----- From: "David Kernberger" <dkern@napanet.net>
>To: "William Langdell" <w.langdell@comcast.net>
>Cc: "Morris" <morris@autox.team.net>
>Sent: Saturday, September 01, 2007 6:21 PM
>Subject: Re: Vega Rims Center Hole
>
>
>David: Thanks for your reply. I believe your meant 2 -11/16", not
>3-11/16". ---Bill Langdell
>
>>Bill et al,
>>
>>A few years ago I had a machine shop do it for me. I believe they
>>used a large lathe. The dimension is 3 11/16" My idea was to take
>>out as litle as possible yet have them still fit around those
>>Morris front hubs. I suspect 3 3/4" would be OK, though I did not
>>want to unncecessarily weaken the wheel.
>>
>>Cheers,
>>Dave K.
>>
>>----------------------------------------------------------
>>
>>>Dear Listers: I just shipped some Chevy Vega wheels to another
>>>lister and he
>>>is asking how to make the center hole bigger to fit on a Morris Minor. Any
>>>suggestions on the correct hole diameter and preferred hole enlargement
>>>method? Thanks for your help. ---Bill Langdell, Sunnyvale "57 Minor 1000
>>Convertible.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morris
|