Randy,
You can't mistake them.
The "thin" plate has a rolled edge and is stamped steel. The "thick" plate
is cast and is basically square edged. Thick plate is about .35 inches.
Gerard
At 8:20 PM -0500 1/16/02, Rkegg465@cs.com wrote:
>Does anyone know the thickness of the thin and thick rear plates? Or is there
>another way to tell which one you have?
>
>Randy Kegg
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morris
|