I have a nice new Tudor water temp gauge and sender to replace the SunPro
gauge that a wild-eyed racer had in my car ('66 4/4 with a triple gauge for
fuel/oil/amps and a single 2" gauge for water). There's a male blade
connector on the sender and a male blade connector on the gauge, along with a
female connector on the gauge. Does the sender connect to the male connector
and 12 volts to the female? That would seem to make sense, but I don't know
where to look. I've been collecting documentation (Lucas manuals, FSBReader,
etc) but none of them get into this level of detail. This darn gauge is
expensive, and before I let the smoke out of it I'd like to have a shot at
connecting it right.
Thanks!!!!
Lannis
|