-- [ From: Bob Nogueira * EMC.Ver #3.1a ] --
-----
> Date: Monday, 22-Feb-99 03:22 PM
>
> From: Blair, John
> Subject: RE: pulling a 4/4 engine
>
SNIP
. There are 3 cross bars - 2 for the front subframe, and
> one for the
> Vallance. Remove the small one for the vallances. The front subframe
will
> limit how
> Far forward you can pull the eng.
>
-------- REPLY, End of original message --------
Will
One hint here, if your bonnet and fenders are currently fitting correctly
then measure the distance between the nuts on the vallance cross bar. Write
the distance and tape it to the bar.
The vallance cross bar has a lot to do with how the fenders and bonnet sit
and knowing what the distance was will save you a lot of trial and error
come reassembly time .
Bob
|