-- [ From: Bob Nogueira * EMC.Ver #3.1a ] --
Expanded recipient data:
To: Sgilbert \ Internet: (sgilbert@wpusd.k12.ca.us)
Steve:
Gray silicone seal works well on the Spoke ends . If any of it comes
through it matches the painted wheels pretty closely . If your going to
paint the wheels after you caulk then, 3M Drip Chek works better than any
other sealer I have ever used.
Bob Nogueira
-------- REPLY, Original message follows --------
> Date: Thursday, 01-Jan-70 12:00 AM
>
> From: Sgilbert \ Internet: (sgilbert@wpusd.k12.ca.us)
> To: jbriske@oro.net \ Internet: (jbriske@oro.net)
> To: MORGANS \ Internet: (morgans@autox.team.net)
>
> Subject: Wheel Repair Questions
>
> I am attempting to replace broken / missing spokes. I plan to wrap
interior
> of rims (over spoke holes) with 10 mill pipe wrap. I also will cover
spoke
> ends inside grease areas with caulking.
>
> Any hints on tightening spokes? I plan to use the sound method... hit and
> compare sound with existing spokes!
>
> What is the best caulking to use???
>
> What else should I do while these are apart???
>
> Thanks
>
> Steve Gilbert
> 67 4/4
> w/proper jack but very few spokes!
> Auburn, CA
-------- REPLY, End of original message --------
|