To all:
Does anyone have a rear suspension design on a previous mini baja that meets
the following criteria:
- Rear Independent Suspension
- Double A-Arm
- Here's where it get tricky (and critical)
- The front mounting point (on the chassis) is higher than the rear
mounting ponit for the same A-arm. In other words, when looking at the side of
the car, the rear a-arms form an angle (other than zero) with respect to the
horizontal. Please see attached diagram for clarification.
I am looking for any pictures, design reports, or just someone with a little
information. I am working on a project and would like all the help I can get.
I'm looking for desing reports, etc, dated prior to 2002 specifically, but at
this point any information would be beneficial!
Thanks,
Joshua Heacock
UISAE President
[demime 1.01d removed an attachment of type image/pjpeg which had a name of
RearSuspensionAngle.JPG]
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mini-baja
|