mini-baja
[Top] [All Lists]

Bend radius

To: <mini-baja@autox.team.net>
Subject: Bend radius
From: "Jon Hastie" <jhastie@coe.neu.edu>
Date: Thu, 9 Sep 2004 17:39:23 -0400
Hey I was wondering if anybody else is having trouble with the new rule
about bend radius.  
 
NOTE: When bent tubing is used as a roll cage member, the inside radius
of the bend must be no less than 5", as measured by a circle gauge
applied to the inside of the bend.
 
This would require a 5.5" Center Line Radius bend for 1" tubing, and a
6" radius for anything larger. 
We were hoping to not have to build a new frame this year as it was
built last year.  As we used a 4.5" Center Line Radius,   with 1-1/8"
tube it looks like we probably will have to start over.   Anyone else
having this problem?
 
Jon Hastie
Northeastern University MiniBaja

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mini-baja


<Prev in Thread] Current Thread [Next in Thread>