Hi,
I have a question about rule 37.4. The rule states:
All ball joints, tie rods in single shear must have a steel safety washer
minimum thickness is 0.18 in.
We have standard factory safety washers that came with the Heim joints. They
are tapered so that the end thickness is less that 0.18 in. Are these washers
acceptable? At what diameter does the thickness parameter apply?
Thanks,
Julie Engel
Bucknell Mini-Baja 2004
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mini-baja
|