You need the CB front air-cleaner bracket for the choke inner. That has
an arm with a hole in the end and the choke inner attaches to that with
a trunnion.
For the throttle you need the link for the short lever underneath the
throttle spindle and you need the heat shield for the outer and for the
return springs for both throttle and choke.
These may help:
http://www.mgb-stuff.org.uk/choke.htm#adjust
http://www.mgb-stuff.org.uk/tcable.htm#1a
http://www.mgb-stuff.org.uk/chshield.htm#2
PaulH.
On 18/05/2023 00:26, dave northrup wrote:
> This is where i am.  Its an mgb engine in an mga. Didn't come with
> carbs so i ordered some off ebay. The engine runs with gas in the
> float bowls; I'm trying to attach the choke and accelerator cables but
> im missing parts.  But i don't know what.  Could really use some
> help here.  And i can cut the choke sheath if need be.
>
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/mgs http://autox.team.net/archive
>
> Unsubscribe:
> http://autox.team.net/mailman/options/mgs/paulhunt73@virginmedia.com
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/mgs http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|