This is a multi-part message in MIME format.
--===============0282289627796204743==
boundary="------------9xaR70ve7vU6agsoScs37t0N"
Content-Language: en-US
This is a multi-part message in MIME format.
--------------9xaR70ve7vU6agsoScs37t0N
Content-Transfer-Encoding: 8bit
This MGA has a single reservoir. The brake side is working, the clutch
side is not. I can not get any pressure pumping the pedal. Here is
what I/'/ve tried so far:
1. Changed out the tubing from the master
2. Got a little fluid out when I cracked the tubing at the master. Fluid
kind of spit.
3. Got a little fluid out when I cracked at the other end of the tubing
4. Fluid in reservoir did not drop when pumping.
5. Took the master out and checked the rubber parts all seemed to be in
order.
6. Covered the output of the reservoir and I could not push the shaft in.
7. Took the master cover off and looked to see if there was something
stopping the fluid from entering the cylinder. Both sides looked the same.
8. Reinstalled the master and no pressure still.
Any other ideas? I think that the fluid id not getting into the
cylinder, but I don't know why.
--------------9xaR70ve7vU6agsoScs37t0N
Content-Transfer-Encoding: 8bit
<html>
<head>
<meta http-equiv="content-type" content="text/html; charset=UTF-8">
</head>
<body>
<p>This MGA has a single reservoir. The brake side is working, the
clutch side is not. I can not get any pressure pumping the
pedal. Here is what I<i>'</i>ve tried so far:</p>
<p>1. Changed out the tubing from the master <br>
</p>
<p>2. Got a little fluid out when I cracked the tubing at the
master. Fluid kind of spit.<br>
</p>
<p>3. Got a little fluid out when I cracked at the other end of the
tubing</p>
<p>4. Fluid in reservoir did not drop when pumping.</p>
<p>5. Took the master out and checked the rubber parts all seemed to
be in order.</p>
<p>6. Covered the output of the reservoir and I could not push the
shaft in. <br>
</p>
<p>7. Took the master cover off and looked to see if there was
something stopping the fluid from entering the cylinder. Both
sides looked the same.</p>
<p>8. Reinstalled the master and no pressure still.</p>
<p>Any other ideas? I think that the fluid id not getting into the
cylinder, but I don't know why. <br>
</p>
</body>
</html>
--------------9xaR70ve7vU6agsoScs37t0N--
--===============0282289627796204743==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/pipermail/mgs http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
--===============0282289627796204743==--
|