If you're asking can you test that the clutch releases/engages without
connecting the hydraulic operating parts - yes. It will require extreme
strength or leverage. A long lever will allow a mortal human to move the
clutch operating fork. It only needs to move ~ 1/2" at the end opposite
the throw out bearing. I've done it with a 2' long pry bar.
With the transmission in gear, try to turn the transmission output
flange. It should not turn if the clutch is engaged to the
flywheel/engine. Now move the operating fork and see if you can turn the
transmission output flange. If yes, the clutch is releasing.
Eric Russell
Mebane, NC
> Date: Sat, 16 May 2020 09:28:32 -0500
> From: "dave" <dave@ranteer.com>
> To: <mgs@autox.team.net>
> Subject: [Mgs] just in case
> Message-ID: <007201d62b8e$476107a0$d62316e0$@ranteer.com>
> Content-Type: text/plain; charset="us-ascii"
>
> 59 mga, body off and painted, almost finished renovating the chassis. Plan
> to marry the drivetrain to the chassis before putting the tub on.
>
>
> I don't see how, but I thought I'd ask, if there is anyway to test the
> clutch without putting the body on and attaching the master/slave
> hudraulics.
>
>
> Car would not shift, removed engine and tran, replaced clutch and throwout
> bearing (dpo had one of those fancy ball bearing throwout bearings which was
> trashed)
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/pipermail/mgs http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|