I just used a old large bolt cut down and tapered. Gave me low-profile head
for a socket spanner for use on the level plug where space is restricted.
The hole for the tool may be square but it isn't parallel-sided. If it were
you could use a 1/2" socket wrench without a socket - which I did for a
while but it tends to slip out. Best of all is to replace them with the new
plugs which take a hex Allen key.
PaulH.
----- Original Message -----
More than one way to skin a cat. I got a
standard 3/8 to 1/2 drive adapter for $1 from a
cheap tool vendor. Grrind the output end to a
little taper, and it's a perfect fit.
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/pipermail/mgs http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|