| To: | "'Eric J Russell'" <ejrussell@mebtel.net>, <mgs@autox.team.net> |
|---|---|
| Subject: | Re: [Mgs] banjo axle breather dilemma |
| From: | dcouncill via Mgs <mgs@autox.team.net> |
| Date: | Sun, 12 Jul 2015 13:08:23 -0700 |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | mgs@autox.team.net |
| References: | <mailman.1.1436724002.9166.mgs@autox.team.net> <C247A7133A064BB2986320B4AB916247@EricJRussellPC> |
| Thread-index: | AQJFx82s8TMTQXRyUkAYaEZV4d0NrQFvhko5nOKw1OA= |
Very much possible - in this case, that was the problem. I was able to remove it and the new breather piece is now installed. David Councill -----Original Message----- From: Eric J Russell [mailto:ejrussell@mebtel.net] Sent: Sunday, July 12, 2015 11:43 AM To: mgs@autox.team.net Cc: dcouncill@karamursel.org Subject: Re: [Mgs] banjo axle breather dilemma > I am working on the rear axle of a 64 MGB. > The hole is threaded but too small for a 5/16? bolt but too large for ??. Is it possible the old breather broke off flush with the axle housing? Eric Russell Mebane, NC _______________________________________________ Mgs@autox.team.net Archive: http://www.team.net/archive Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Mgs] banjo axle breather dilemma, Eric J Russell via Mgs |
|---|---|
| Next by Date: | [Mgs] 1954 MG TF Robbins Top Installation, Donald Joseph Toy via Mgs |
| Previous by Thread: | Re: [Mgs] banjo axle breather dilemma, Eric J Russell via Mgs |
| Next by Thread: | [Mgs] 1954 MG TF Robbins Top Installation, Donald Joseph Toy via Mgs |
| Indexes: | [Date] [Thread] [Top] [All Lists] |