Clayton,
When set properly, he feeler gauge should be snug and yet able to slide
between the valve stem the rocker arm without binding. Setting the
clearance too tight may prevent the valve from closing completely, too loose
and the valve will not open completely.
I think a SLIGHT tapping nose in the valve train is OK.
John DIFede
1973 MGB
When I went to reset the tappet clearance, I found the old settings rather
sloppy. I reset them so that the gauge was snug - it slid in but it
definitely tight. Which is correct? I know that it makes a difference on
performance and full combustion. Yes, I did the checking while hot.
TIA,
Clayton
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/mgs/attachments/20150517/876aff72/attachmen
t-0001.html>
------------------------------
Subject: Digest Footer
_______________________________________________
Mgs mailing list
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
------------------------------
End of Mgs Digest, Vol 96, Issue 7
**********************************
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|