Bill, Make sure your float arm isn't bent so that it can drop low enough for
the needle to jam.
If your in an area using ethanol, you might try a small amount of Marvel
Mystery oil in your gas.
You also could consider grose jets which are easy to install but I found those
can stick with ethanol as well but MMO occasionally takes care of it.
Mike
On Oct 12, 2013, at 1:00 PM, mgs-request@autox.team.net wrote:
> Date: Fri, 11 Oct 2013 08:38:25 -0400
> From: "Bill Snyder" <wtsnyder@bellsouth.net> wrote
>
>
> Hello list. I have a 66 MGB that hasn't been driven much this year. Took it
> out yesterday on a very nice Smoky Mountain day. I have two issues that
> require advice. The needle valves on both carb float bowls stick
> occasionally. Is there a proper way to clean or lubricate them to prevent
> sticking?
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|