Last year I got an alloy valve cover, and a new valve cover gasket. Along with
thumb screws to hold it down.
I couldn't get it to not leak. The gasket just wouldn't sit straight on it.
And the thumb screws kept coming loose.
I tried some lock tight on the screws and use a slip joint pliers on them to
get it tight. However, the gasket still was bad.
So, I pulled by old stock valve cover back on, but the rubber grommets have
perished, so I can't get it tight either.
I'm going to go to Quality Coaches in Minneapolis tomorrow and get a new
gasket and grommets, etc.
Anybody have any hints on getting that gasket to fit on the alloy?
Thanks,
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|