[Mgs] MGA door rails

mgs

[Mgs] MGA door rails

To:	<mgs@autox.team.net>
Subject:	[Mgs] MGA door rails
From:	"Eric J Russell" <ejrussell@mebtel.net>
Date:	Sat, 24 Nov 2012 22:23:16 -0500 a=P2oOn6vrs4wA:10 a=S2wpYzp2RsyRkoRNwqcm1Q==:17 a=LGTk_pXoecJrAG24MOwA:9 a=wPNLvfGTeEIA:10 a=dCd18mX31KZLKK5oSM8A:9 a=_W_S_7VecoQA:10 a=XEwQNxpNHtSO-ZKU:21 a=S2wpYzp2RsyRkoRNwqcm1Q==:117 reip=0.000, cl=1, cld=1, fgs=0
Delivered-to:	mharc@autox.team.net
Delivered-to:	mgs@autox.team.net

I am planning to make some new door capping rails for my MGA. But I have no
originals to copy. Is the inside at a right angle to the bottom or slanted?

i.e. in cross section are they like this?

                  _______
                 /            |
  outside   /              |   inside
              /_________|


or like this?
                ________
               /              /
              /              /
             /________/


Eric Russell
Mebane, NC
_______________________________________________

Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
[Mgs] MGA door rails, Eric J Russell <= Re: [Mgs] MGA door rails, Barney Gaylord

Previous by Date:	Re: [Mgs] Importance of 3 screws in float chamber lid, PaulHunt73
Next by Date:	Re: [Mgs] MGA door rails, Barney Gaylord
Previous by Thread:	[Mgs] Importance of 3 screws in float chamber lid, Simon Matthews
Next by Thread:	Re: [Mgs] MGA door rails, Barney Gaylord
Indexes:	[Date] [Thread] [Top] [All Lists]