I have a set of open-end ignition wrenches made by Giller; don't
remember how I came by them. There are a couple of interesting sizes:
1/4 x 15/64 & 11/32 x 9/32. Haven't used them in years.
CR
On 11/11/2012 10:31 AM, " Just Brits " Shop wrote:
> Glenn & guys;
> I seem to recall Snap-On selling a three (3) piece SET of "Ignition
> Wrenches" MANY, MANY years ago. However Glenn & IIRC, the largest was
> 7/16" & 3/8" then 3/8" & 1/4" them 1/4" & 3/16". All three (3) were of
> thin-wall construction with both 'heads' at 90 degrees to the shaft.
> As usual, Snap-On would & did sell the wrenches separately <VBG> ! ! !
> Sorry Glenn, but I do NOT re-call a 4th wrench with would have been
> 7/16" & 1/2" or the "set" starting there and going down in size (I am
> next to positive on this - LOL) ! ! ! If I can find my 7/16" & 3/8"
> wrench, I get ya'll some pics and measurements. 'Big' one is about
> three.five" ( 3 1/2") long. Ed Please visit MY site at:
> www.justbrits.com PS: <lite bulb going off> Eureka, Sears had a
> roll-up kit in red plastic & IIRC, wrenches were Craftsmen.
> _______________________________________________ Mgs@autox.team.net
> Donate: http://www.team.net/donate.html Suggested annual donation
> $12.75 Archive: http://www.team.net/archive Forums:
> http://www.team.net/forums Unsubscribe:
> http://autox.team.net/mailman/options/mgs/ccrobins@ktc.com
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|