Hello Friends,
A number of you expressed interest in following the rebuild of Jack's '65
Elan's Weber 40DCOE/18 carbs. I posted a few picture links earlier. If
interested, you may have seen them. Today I write just to report that the
first carb's rebuild is progressing nicely.
The carburetter is disassembled, which was no minor feat given that it was
glued together with 10 years of gum. Still, the Chem-Dip did its job on most
bits. RustEater freed the remaining bits (like the choke valves). And I can
now report that the carb body is clean (and beautiful) with all passages clean,
clear and undamaged, awaiting reassembly. All jets and tubes have also been
cleaned and are undamaged. Next step is to verify that the various jets and
tubes match the stock Elan specification. Who knows what monkeying-around may
have been done by some PO.
Jack brought the rebuild kits over to me last weekend so I have everything I
need to put the first of these instruments back together. I'll share photos of
the whole reassembly, starting with setting the float level properly.
Until then...
regards,
-rick
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net
|