Thanks Max,
I'll verify this - if that's the case, it is easy to correct.
Cheers,
Hans
----- Original Message -----
From: "Max Heim" <mvheim@sonic.net>
To: "MG List" <mgs@autox.team.net>
Sent: Sunday, September 09, 2012 3:24 AM
Subject: Re: [Mgs] Drive shaft balanced
> The other thing to check is that it is assembled correctly. It can be
> taken
> apart at the sliding spline. When reassembled, the u-joint yokes need to
> be
> parallel. If the spline is off a tooth, it will vibrate.
>
> --
>
> Max Heim
> '66 MGB GHN3L76149
> If you're near Menlo Park, CA,
> it's the primer red one with chrome wires
>
>
> on 9/8/12 2:27 PM, Charley & Peggy Robinson at ccrobins@ktc.com wrote:
>
>> Are you sure it's not a U-joint going bad?
>>
>> CR
>>
>> On 9/8/2012 4:01 PM, Hans Duinhoven wrote:
>>> Hi,
>>>
>>> After some tests at several revs of the engine and speed I finally
>>> found, that some vibrations between the speed of 50 and 70 m/h are
>>> caused by I think an unbalanced driveshaft between the gearbox and the
>>> differential gear.
>>> What is the cause of this?
>>> Can this be rebalanced and if so - how?
>>> Is it easier to replace the driveshaft with a used one instead of
>>> rebalancing the one, which is on the car?
>>>
>>>
>>> Cheers,
>>>
>>> Hans
>>> 71 BGT
>>> no overdrive _______________________________________________
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/mgs/h.duinhoven@planet.nl
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net
|