Thanks for the feedback. One thing I did notice is my gaiter (the torn
one) is dry inside. (At least nothing is oozing out on the floor from
the torn one.) That concerned me. I haven't poked at the other one
yet. What wears out in there? (The oil should have been lubing
something right?)
I have owned the car since '96 and never had anything leaking out of the
gaiters. What do I need to inspect to make sure something isn't worn out
from running dry?
I will take your advise on the tie rod ends. I remember one of those
broken on a one of my father's trucks... It was exciting.
Also, please notice the updated gator spelling... :)
--
Andrew
On 09/04/2012 09:50 AM, mgbob@juno.com wrote:
> Opinion seems to be unanimous that replacing gaiters is the thing
> to do. I would have recommended the same.
> The tie rod ball joints have to come off to do the job. I the
> joints are not perfect, now is a time to replace them also.
> Here's how I do the job, rather more frequently than I would like
> as today's rubber just does not seem to last all that long.
> Remove tie-rod end from the wheel arm. Some use a fork (ok if you
> are replacing the tie-rod end), some a puller, and some use two large
> hammers.
> Back off the lock nut one flat, then mark it or tape it to hold it
> there. Unscrew the tie-rod end and count the turns as you do so. If
> you re-use it, you will have the turns counted to help you put it back
> on, and the lock nut to confirm its position. If you are using new
> ones, at least you should be near where the alignment adjustments belong.
> Cut off the old gaiter, Catch the gooey oil in a pan, each side.
> Wipe it all clean, and if you have any reason to suspect grit has got
> in there, spray it clean with WD40 or paint thinner or kero.
> Install the new boots. Use the clamp or tie-wrap on large end,
> leaving small end loose.
> Specified oil is 1/3 pint of 90w gear oil. I use a syringe to squirt
> it in the small ends of the gaiters.
> Screw on the tie-rod ends and bring back the locknut from its parked
> position.
> Check the alignment. If it's ok, tighten the clamps on the small
> ends and go driving.
> Bob
>
>
> ---------- Original Message ----------
> From: "Andrew B. Lundgren" <lundgren@byu.net>
> To: mgs@autox.team.net
> Subject: [Mgs] Torn gator
> Date: Mon, 03 Sep 2012 10:41:23 -0600
>
> I haven't done anything with the rack and pinion on my car. I found
> that one of the gators has torn open. (old and rotten) I don't know
> much about these so I started looking in my manual and online and found
> the entire replacement racks.
>
> At 40 years on the car, is this something I should consider rather than
> just replacing the gators? I don't put a lot of miles on the car, the
> odometer shows about 75k on it and that is probably correct within 10k
> miles.
>
> Thanks!
>
> --
> Andrew
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/mgs/mgbob@juno.com
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net
|