[Mgs] Can't remove clutch slave components

[steve at shoyer.com (Steve Shoyer)]

Thanks to everyone who responded on the list and offline.  I was finally
able to get the pipe disconnected from the hose without breaking the pipe,
so it looks like I don't need to pull the engine for this job - yet, anyway.
The new push rod is longer than the old one, so I still need to remove the
clevis pin, but there's more clearance to get to it so I hope it won't be
too much of an ordeal.

--Steve (1980 MGB)

----- Original Message ----- 
> I'm trying to replace my clutch slave cylinder, as well as the hose 
> leading to it, but I can't loosen the fitting on the pipe that 
> connects to the clutch hose...