18GB I assume.
70 ft lb, according to the Workshop Manual. However that only appears under
the 18V section, but Haynes gives the same figure for 'all models' which
seems more than likely.
PaulH.
----- Original Message -----
From: "Martin C. Galan" <batangelias@yahoo.com>
To: <mgs@Autox.Team.Net>
Sent: Friday, August 05, 2011 9:51 AM
Subject: Re: [Mgs] Crankshaft Pulley
> Hello All,
>
> Can any one in the list please point me to a page where I can get the
> proper torque setting for the crankshaft pulley of my 18B engine?
>
> Thank you.
>
> Martin Galan
> 65' MGB
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/mgs/paul.hunt1@blueyonder.co.uk
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|