Yes, the pads are the same. My first thought was that they weren't, but I
confirmed that they were.
The issue is the clearance on the inside side caliper is smaller that the
clearance on the outside.
I got a new caliper because I thought the piston was the thing that was
binding, but the piston couldn't move the pad once wedged in there.
On Jun 9, 2011, at 1:42 PM, mgbob@juno.com wrote:
> Paul,
> Are not all four pads the same? I have a new set of Mintex pads in hand,
and they seem to be.
> Does the calliper move easily, sliding in and out? As there is one piston,
the pressure of the piston moves the calliper to center the assembly on the
disc.
> Sticking of the calliper does not seem to be your question, though.
> Bob
>
> ---------- Original Message ----------
> From: Paul Root <ptrmgb@gmail.com>
> To: MG List <mgs@autox.team.net>
> Subject: [Mgs] brake pads
> Date: Thu, 9 Jun 2011 12:53:44 -0500
>
> I found the problem with my brakes binding up and pulling hard to the
right.
>
> It seems the Classic Gold pads I bought don't fit. I forced them in enough
to
> get the cotter pin in and figured it would seat itself correctly, but no,
it
> didn't, the inside pads got stuck, and wouldn't move in the caliper.
Measuring
> they are a good .02-.03 inches wider than the stock pads I pulled out.
>
> I've sent mail to Kelvin about it, but he's on vacation (probably in his
barn
> under a car :-) ).
>
> I'm wondering if I could grind the edges (metal backing) to make them fit?
The
> outside pads fit fine.
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/mgs/mgbob@juno.com
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|