Take the plugs out and turn the engine with your thumb over No.1 plug hole.
On the compression stroke your thumb will be lifted off the hole, when the
piston is at the top of that stroke that is TDC for No.1 For the purposes
of reconnecting the plug leads, that is. But if you mean accurate TDC for
timing purposes you need a stop screwed into No.1 (or No. 4) plug hole, turn
the engine one way until the piston just touches the stop and mark the
pulley in line with the TDC pointer, then turn the engine the other way
until the piston contacts the stop and mark again. Timing TDC is between
the two marks.
PaulH.
----- Original Message -----
> Any help in determining when no 1 is at TDC for ignition timing?
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|