As far as I know it is correct; it doesn't feel unreasonable, but how would
I find out?
crk
-----Original Message-----
From: Steven Trovato [mailto:strovato@optonline.net]
Sent: Thursday, October 07, 2010 12:32 PM
To: Clayton Kirkwood; 'MG List'
Subject: Re: [Mgs] rocker threads causing problems
Are you sure that your torque wrench is correct? 25 ft-lbs isn't
really very much torque.
-Steve Trovato
strovato@optonline.net
At 03:04 PM 10/7/2010, Clayton Kirkwood wrote:
>Hi,
>
>
>
>I am putting my rocker assembly back on my head after putting new valve
stem
>oil seals in in an attempt to see where my oil consumption is coming from.
>While tightening the nuts down on the studs, I continue to have a problem
>with the threads of the nuts ripping out.
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|