You need to set the shim pack anytime you replace the bearings. Consult your
Bentley's manual. You will need an assortment of shims.
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
on 8/29/10 4:21 PM, James Schulte at schultejim@msn.com wrote:
> Folks
> I pulled the right front wheel and disassembled the bearings due to it having
> too much play on my 70B. The outside bearing (smaller of the 2 ) was charred
> like it might have been over tightened. I'm replacing it with a new set of
> bearings. There was a really thin shim that was stuck on the cone shaped
> spacer. Not sure what size. Any hints or tips welcome.
>
> Jim Schulte
> VP Lehigh Valley Kayak & Canoe Club
> ACA Instructor
> _______________________________________________
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|