The OD switch isn't polarized -- It doesn't matter which lead goes to which
prong.
Can't help find your bolts, alas...
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
on 7/19/10 4:24 PM, Malcolm Jeffcock at msjeffcock@eastlink.ca wrote:
> Hello listers:
>
> engine progresses but as with everything another bump:
>
> Can anyone tell me the size/thread of the two bolts which hold in the clutch
> slave cylinders? Are they SAE or "English thread"? It has been so long since I
> removed mine I can't find them! They are, I know, held together with masking
> tape and labeled but I cannot find where I put them! This one is on me,
> searched the garage, found my wire cutters but cannot locate the two bolts!
>
> As well any directions on the wiring for the o/d? I had tape on them
> reconnected them first but took no notice and they have come off, perhaps a
> cat perhaps just with jiggling engine trying to get on the engine mounts,
> doesn't matter and I should have left tape on them but didn't...
>
> Malcolm--hoping to drive his MG this weekend!
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|