the clutch has less than 8k miles on it so I was just going to pop it back in.
Both fly wheels look fine which is prompted the question
----- Original Message -----
From: Larry Yockell
To: Malcolm Jeffcock
Sent: Saturday, June 19, 2010 8:31 PM
Subject: Re: [Members2] ] mg engine
Hi Malcolm
I would be only concerned about the condition of the friction surface of the
flywheel and the condition of the teeth on the flywheel.
You are not putting a new clutch since you have the engine out?
Larry
----- Original Message -----
From: Malcolm Jeffcock
To: mgs@autox.team.net
Cc: members2@batans.ca
Sent: Saturday, June 19, 2010 8:26 PM
Subject: Re: [Members2] ] mg engine
Quick question...when I put in the replacement engine should I keep the fly
wheel that was on that engine before I put on the clutch or use the fly wheel
off the removed anging to which the clutch had been associated?
I suspect just keeping the engine/flywheel pairing should be preferred but
just want to check...
Malcolm
----------------------------------------------------------------------------
_______________________________________________
Members2 mailing list
Members2@batans.ca
http://batans.ca/mailman/listinfo/members2_batans.ca
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|