Bob, replace the flasher unit. seems to work , heat up, and does not
work again.
paul
>I have an MGA 1600 with the pnuematic turn signal switch on the dash
>(Moss #162-400), and the barrel type flasher unit on the firewall
>(Moss # 141-750). The pnuematic part of the turn signal switch
>never worked so I just hold it to the side until I finish my turn.
>Recently, holding the lever only initiates two -- and only exactly
>two -- blinks on the turn signal lamps. The same thing happens
>with the front and back lamps and on either side. Is this a turn
>signal switch problem, or a flasher unit problem? Is there a
>diagnosis protocal to follow to isolate the problem? I never
>repaired pnuematic turn signal switch because one of the screws
>holding the case of the switch together is stripped (the head is
>intact, but it and turns freely in the threads without moving out
>-- most curious). Thank you.
>--
>Robert Guinness
>__
--
Paul Osborne
University of Rochester
Engineering & Technical Services
Department of Electrical and Computer Engineering
201 Hopeman Bldg River Campus
Rochester, New York 14627
585-275-5226
paul@ece.rochester.edu
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation - $16.22
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|