Only takes a min. do it again, just to make sure nothing is wrong .
paul
>No. I did one before the head was replaced and that is how I found
>that I had a bad valve.
>Tom
>----- Original Message ----- From: "Paul Osborne" <paul@ece.rochester.edu>
>To: "Richard Ewald" <richard.ewald@gmail.com>
>Cc: <mgs@autox.team.net>
>Sent: Saturday, January 30, 2010 8:25 AM
>Subject: Re: [Mgs] weber or not
>
>>Have you done a compression test?
>>paul
>>
>>>Along the same line, if there is a blown head gasket between 3 and 4,
>>>rebuilding the carbs won't help much.
>>>Rick
>>>
>>>On Fri, Jan 29, 2010 at 3:52 PM, gordies garage
>>><mg_garage@comcast.net>wrote:
>>>
>>>> Tom, have you confirmed that you are getting fire to #3 & #4?
>>>_______________________________________________
>>
>>
>>--
>>Paul Osborne
>>University of Rochester
>>Engineering & Technical Services
>>Department of Electrical and Computer Engineering
>>201 Hopeman Bldg River Campus
>>Rochester, New York 14627
>>585-275-5226
>>paul@ece.rochester.edu
>>_______________________________________________
>>
>>Support Team.Net http://www.team.net/donate.html
>>
>>Suggested annual donation - $16.22
>>
>>Mgs@autox.team.net
>>http://autox.team.net/mailman/listinfo/mgs
>>
>>Subscribed as thgun@comporium.net
>>
>>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation - $16.22
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|