David, give a look at tptools.com. they are great when it comes to
blasting. I have one of their homemade cabinets and have been using
their "first choice" abrasive. $30 for 50lbs great stuff. I power
it from my 5hp compressor with a 50 gal tank, that to is a home built
unit. any ways ck them out they have a lot of useful infomation
about blasting , types of abrasive, parts etc.
As you use your to clean parts remember to wash the parts before you
stat to paint. The abrasive will pit the surface some but after a
few coats of primer, lite sand in between, and the same with paint
coat , you should be very happy with the results.
paul
>I have purchased a blast cabinet from Horrible Freight because the price
>was right and it will be handy during my latest restoration of a 64B.
>The question I have concerns the media. I have immediate need to clean
>up parts like rusty pedals, brake cover, air filters assemblies to think
>of a few and wonder about what sandblasting media would be best. HF was
>limited on selection and my initial research indicated the best blast
>media for the application would probably be a fine aluminum oxide
>abrasive. All they had was the 70 grit and the staff person thought I'd
>be better off with the out of stock 220 grit. For those of you with
>sandblasting equipment, what do you use or recommend for blast media?
>
--
Paul Osborne
University of Rochester
Engineering & Technical Services
Department of Electrical and Computer Engineering
201 Hopeman Bldg River Campus
Rochester, New York 14627
585-275-5226
paul@ece.rochester.edu
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|