Loosely refit the hub and simply tap with a soft hammer or mallet on
opposite sides alternately and it should pull the bearing out, it is only a
light interference fit.
PaulH.
----- Original Message -----
> I am replacing the thrust washers on my "72 MGB. Got the hub off along
> with
> the backplate, and now need to slide the axle out a short bit. What is the
> secret to getting it to slide out? Thanks in advance for any help.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|