Barney, attached are some photos I snapped of a spare frame with a tape
measure for reference. Let me know if this is not what you need. Also let me
know if you need higher resolution copies.
Eric Russell
Mebane, NC
http://home.mebtel.net/~ejrussell
----- Original Message -----
> Date: Sun, 06 Dec 2009 00:36:42 -0600
> From: Barney Gaylord <barneymg@mgaguru.com>
> Subject: [Mgs] MGA frame width at rear
> For those people who may have an MGA chassis or frame with body off,
> can you measure the inside and outside width of the frame where the
> rear bumper brackets attach? I would like measurements from two or
> three different frames to verify consistency (or amount of possible
> variation). I need this for a wheel chair lift I'm working on that
> will attach to the frame similar to a trailer hitch bracket.
>
> Barney Gaylord
> 1958 MGA with an attitude
> http://MGAguru.com
[demime 1.01d removed an attachment of type image/jpeg which had a name of
frame 01.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
frame 02.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
frame 03.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
frame 04.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|