<< But you should check to see if the thread is still good near the end
of the
stud -- usually it only strips where the nut sits. If so, you could
justpile on 2
or 3 thick washers, to move the nut out to the good part of the thread. >>
That's exactly what I've had to do a couple times in the past,
Max !! And I 'trimmed' them down to just a tad bigger then
the nut.
Ed
Please visit MY site at:
www.justbrits.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|