I finally got around to power washing my engine so I could
definitively tell that my slight oil leak was the tappet covers.
Saturday, I'm going to replace the gasket on them.
Are there any tricks or "been there, done that, don't do what I did"s?
I figure it's
Remove carbs
Remove exhaust manifold
remove covers
clean covers
scrap every bit of old gasket off covers
make sure covers aren't warped
gasket goo the gasket to the cover, let cure
put on engine
replace manifold
replace carbs
drive, be happy.
I now return you to your regularly scheduled female chest
discussion. :-)
a Paul.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|