I'm looking forward to hearing what you discover is wrong. I just
milled my 1500 head to get 37cc volume and decked the block to make the
pistons level with the top of the block. Even with that, I had plenty
of adjustment with stock pushrods, although in my case, the stock setup
was MGB 18V parts.
thgun@comporium.net wrote:
> I have talked to a few people about this and I am still not clear as to how
>to go about fixing my problem. I purchased a redone head. Now a few of the
>valves are too tight to adjust. Can I use shims all the way across to raise
>the rocker assembly? If so where can I get them? Any other tips.
> Thanks for the help,
> Tom Gunderson, 1957 MGA 1500 rst
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
>
> You are subscribed as james.f.juhas@snet.net
>
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|